Construction Repair & Strengthening
MasterBrace ADH 2200 is a non slumping epoxy
bedding compound and adhesive. It is a two pack,
fine aggregate filled, fast curing material, ideal for
a variety of bedding, gap filling and concrete repair
applications.
MasterBrace ADH 2200 is a stiff but easily
workable compound that can be applied by either
trowel, spatula or knife. It cures to give high
mechanical properties typical of epoxy
compounds. It is resistant to oils, greases,
petroleum, salts, many acids and alkalis and most
commonly met corrosive media. It does not shrink
on curing, and is designed to be used when cured
from below freezing point to 60°C. Its impact
resistance, and mechanical strength is greater
than that of concrete
masterbraca adh 2200 datasheet
MasterEmaco S 486 is formulated for use at plastic consistency, and may be used with confidence for bedding, repairing, grouting and void filling operations such as:
• Concrete repairs.
• Void filling between old and new concrete.
• Floor patching.
• Packing under columns and stanchions.
• Caulking of concrete pipes.
• Filling tie-bar holes.
• Re profiling of stanchion or mast bases when formwork is undesirable
MasterEmaco S 488 is a pre-bagged ready-to-use
structural repair mortar in powder form. When mixed with
the correct amount of water, it produces a thixotropic,
high strength repair mortar, reinforced with acrylic
polymer fibre.
It possess excellent bond characteristics to steel
reinforcement and to concrete.
MasterEmaco S 488 mortar is shrinkage compensated.
It has low permeability and is extremely durable.
MasterEmaco S 488 contains no metallic aggregate and
is chloride-free.
All types of structural repair which can be applied by trowel or wet spray
• Repair of structural members subjected to repetitive loading
• Repair to reinforced or pre-stressed beams or columns
• Protection of concrete subject to attack from water containing chlorides and sulphates, etc.
• Repairs in industrial areas, especially those containing mineral oils and lubricants
• Repairs in marine environments
MasterEmaco N 303RS is a single component acrylic polymer modified repair mortar for use as a "fairing coat" or cosmetic mortar. When mixed with water, as directed, a fine grey trowellable mortar results which can readily be applied to fill in pores, blowholes and blemishes on a concrete surface.
MasterEmaco N 303RS can be used as a 'skim' coat prior to the application of protective coatings.
MasterEmaco N 303RS is specially formulated to
produce a shrinkage compensating mortar with no cracking when applied in a thin section. Adhesion to concrete and flexibility are excellent.
MasterEmaco FC1000 premix plaster fine finish is a
Grey powder. It is used to achieve proper
smoothening of concrete surface and to eliminate
irregularities of concrete, bubbles, honey combs or
cracks. It can be applied on both, Interior and exterior
walls and ceilings. It has better compatibility with the
base plaster and forms a durable base for paints,
MasterEmaco FC1000 cementitious coat is designed
for vertical and overhead use to infill honeycombing
and voids up to 3 mm deep in the surface of concrete.
It can also be applied as a render from a featheredge
up to 3 mm thick and as blowhole filler up to 10 mm
deep.